Polymer Injectivity: Influence of Permeability in the Flow of EOR Polymers in Porous Media

Al-Shakry, Badar (University of Bergen / NORCE Energy) | Shaker Shiran, Behruz (NORCE Energy) | Skauge, Tormod (Energy Research Norway) | Skauge, Arne (University of Bergen / NORCE Energy)

OnePetro 

Abstract

Application of polymer flooding as a chemical Enhanced Oil Recovery (EOR) has increased over recent years. The main type of polymer used is partially hydrolyzed polyacrylamide (HPAM). This polymer still has some challenges especially with shear stability and injectivity that restrict its utility, particularly for low permeability reservoirs. Injectivity limits the possible gain by acceleration in oil production due to polymer flooding. Hence, good polymer injectivity is a requirement for the success of the operation. This paper aims to investigate the influence of formation permeability on polymer flow in porous media.

In this study, a combination of core flooding with rheological studies is presented to evaluate the influence of permeability on polymer in-situ rheology behavior. The in-situ flow of HPAM polymers has also been studied for different molecular weights. The effect of polymer preconditioning prior to injection was studied through exposing polymer solutions to different extent of mechanical degradation.

Results from this study reveal that the expected shear thinning behavior of HPAM that is observed in rheometer measurements is not observed in in-situ rheology in porous media. Instead, HPAM in porous media exhibits near-Newtonian behavior at low flow rates representative of velocities deep in the reservoir, while exhibiting shear thickening behavior at high flow rates representative of velocities near wellbore region. The pressure build-up associated with shear thickening behavior during polymer injection is significantly higher than pressure differential during water injection. The extent of shear thickening is high during the injection of high Mw polymer regardless of cores' permeability. In low permeable Berea cores, shear thickening and mechanical degradation occur at lower velocities although the degree of shear thickening is lower in Berea to that observed in high permeable Bentheimer cores. This is ascribed to high polymer retention in Berea cores that results in high residual resistance factor (RRF). Results show that preshearing polymer before injection into porous media optimizes its injectability and transportability through porous media. The effect of preshearing becomes favorable for the injection of high Mw polymers into low permeability formation.

This study discusses polymer in-situ rheology and injectivity, which is a key issue in the design of polymer flood projects. The results provide beneficial information on optimizing polymer injectivity, in particular, for low permeability porous media.