Al Ayesh, A. H. (Department of Geoscience and Engineering, Delft University of Technology) | Salazar, R. (Department of Geoscience and Engineering, Delft University of Technology) | Farajzadeh, R. | Vincent-Bonnieu, S. | Rossen, W. R.
Foam can divert flow from higherto lower-permeability layers and thereby improve vertical conformance in gas-injection enhanced oil recovery. Recently,
The effectiveness of diversion varies greatly with injection method. In a SAG (surfactant-alternating-gas) process, diversion of the first slug of gas depends on foam behavior at very high foam quality. Mobility in the foam bank during gas injection depends on the nature of a shock front that bypasses most foam qualities usually studied in the laboratory. The foam with the lowest mobility at fixed foam quality does not necessarily give the lowest mobility in a SAG process. In particular, diversion in SAG depends on how and whether foam collapses at low water saturation; this property varies greatly among the foams reported by Kapetas et al. Moreover, diversion depends on the size of the surfactant slug received by each layer before gas injection. This of course favors diversion away from high-permeability layers that receive a large surfactant slug, but there is an optimum surfactant slug size: too little surfactant and diversion from high-permeability layers is not effective; too much and mobility is reduced in low-permeability layers, too. For a SAG process, it is very important to determine if foam collapses completely at irreducible water saturation.
In addition, we show the diversion expected in a foam-injection process as a function of foam quality. The faster propagation of surfactant and foam in the higher-permeability layers aids in diversion, as expected. This depends on foam quality and non-Newtonian foam mobility and varies with time of injection. Injectivity is extremely poor with foam injection, but is not necessarily worse than waterflood in some effective SAG foam processes